Welcome to the official website of Wuxi heavy industry miniature bearing factory!
Company news
POSITION:HOME > EN > NEWS > Company news >
The characteristics of stainless steel bearing 2016/11/18
Bearing ring and roller materials used in AISI SUS440C stainless steel (9 cr18mo, 9 cr18 domestic brands:) by the vacuum quenching tempering treatment, AISI304 stainless steel cage and seal skeleton materials (domestic brands: 0 cr18ni9). C...
The reason of fracture failure of stainless steel bearings 2016/11/18
Stainless steel bearing failure of the main reason is that defects and overload two factors. When the loads more than material strength limit fracture caused by parts called overload fracture. Overload reason mainly is the main engine failu...
Deep groove ball bearings 2016/11/18
Deep groove ball bearing is one of the most common types of rolling bearing. Basic deep groove ball bearing consists of an outer ring, an inner ring, a set of steel ball and a set of cage. Deep groove ball bearing type has a single row and...
Self-aligning ball bearing work requirements 2016/11/18
For the heavy load, working conditions or have special request for seal bearing configuration, can use the built-in contact type sealed spherical roller bearings. The same with the sealed bearing, bearing dimension on many occasions to repl...
Outside the spherical bearing 2016/11/18
Although its basic performance with deep groove ball bearings should be similar, but because of the bearing are mostly applied in mechanical rough, installation location is not accurate, the axis of the shaft with a hole to neutral, or unde...
A brief introduction of non-standard bearings 2016/11/18
The non-standard bearings, popular, is not conform to the requirement of national standard dimension of bearing, that the dimensions is different from all the bearing of national standard. Its main characteristic is, low degree of generalit...
Non-standard bearing rust prevention methods 2016/11/18
Surface cleaning: 1, surface cleaning: cleaning must be rust in accordance with the nature of the surface and the conditions, select the appropriate method. There are usually used solvent cleaning, chemical cleaning and mechanical cleaning....